- #GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER INSTALL#
- #GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER DRIVERS#
- #GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER DRIVER#
- #GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER SOFTWARE#
- #GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER WINDOWS 8.1#
#GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER SOFTWARE#
This package installs the software (SmartCard Reader Driver) toenable the following device. Compatible only with Motherboards based on Intel 300 Series Chipsets ….
#GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER WINDOWS 8.1#
In Exercise 3.05, we use the Web enrollment application to set up a smart card with a logon certificate for one of our users.DRIVERS BPS N99 FOR WINDOWS 8.1 DOWNLOAD. In much the same way that employee access cards are monitored to ensure that unidentified persons do not gain physical access to your facility, smart card certificates need to be monitored to ensure that only authorized users can view network resources. The enrollment process must be a controlled procedure. Once you've established the appropriate security for the certificate templates and installed smart card readers on your users' workstations, you can begin the process of issuing the smart card certificates.
#GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER INSTALL#
If a smart card reader is attached to a serial port, it's likely that you'll need to reboot the machine before Windows will detect the device and install the appropriate driver. Otherwise, the Add Hardware Wizard will prompt you for the location of the relevant software. If the driver for the reader is preinstalled in Windows Server 2003, the installation will take place automatically. To install a smart card reader on your computer, simply attach the reader to an available port, either serial or USB, or insert the reader into an available PCMCIA slot on a laptop. Table 3.1 Supported Smart Card Readers Under Windows Server 2003
#GEMPLUS GPR400 PCMCIA SMART CARD READER DRIVER DRIVERS#
The corresponding device drivers will be installed on the workstation or server when the card reader has been detected by the operating system.
As of this writing, the smart card readers listed in Table 3.1 are supported by Windows XP and Windows Server 2003. If you're using a reader that is not Plug-and-Play compatible or has not been tested by Microsoft, you'll need to obtain installation instructions from the card reader's manufacturer. Most smart card readers are Plug-and-Play compatible under the Windows Server 2003 software family, so their actual installation is relatively straightforward. Finally, you'll need to train your users on the new procedure to log on to a smart card-protected workstation, since the familiar Ctrl + Alt + Del key sequence will no longer be used. Along with these technical issues, you will also be required to create and document policies regarding identification requirements to receive a smart card or reset a forgotten PIN. Once the necessary hardware is in place, you'll use the Enrollment Station to install Smartcard Logon or User certificates in each user's smart card as well as setting initial PINs for them to use.
Assuming that the readers are Plug-and-Play compatible, the hardware installation process should be fairly simple. On the hardware side, you need to purchase and install smart card readers for all your users' workstations.
The process of setting up your company's employees to use smart cards includes hardware, software, and administrative considerations.